Why it matters
The PM01 is a small submersible pump with a built-in level sensor that switches it on and off. It sits in a tray or tank and lifts water about 3 ft, enough to empty a dehumidifier tank into a nearby sink or drain.
Its bottom-suction design pulls water down to about 1 in, and it waits a few seconds after the level drops before stopping.
Who it's for, and who should skip it
Good fit if
- Dehumidifiers
- Air coolers
- Short lifts into a nearby sink
Look elsewhere if
- Furnaces and central AC
- Any lift over 3 ft
- Unattended appliances that need an overflow switch
Pros and cons
Pros
- Automatic level sensor
- Very small
- Inexpensive
Cons
- 3 ft lift only
- No overflow safety switch
- Lesser-known brand
Limitations to weigh
- Clean the tank, float and check valve every six months or so; algae and slime cause most condensate pump failures.
- With only about 3 ft of lift, it can't reach a drain much higher than the appliance.
Specifications
Every figure below comes from the source shown in brackets. Where the maker doesn't state something, we say so instead of estimating.
| Material | Plastic | Retailer |
|---|---|---|
| Dimensions (seller) | 2.68"L x 1.97"W x 3.15"H | Retailer |
| Product weight | 8.32 ounces | Retailer |
| Max flow (maker) | 1.16 GPM | Retailer |
| Max head / lift (maker) | 3 ft | Retailer |
| Voltage | 110 V | Retailer |
| Compatible devices | Dehumidifier, Air Conditioner, Ice Maker, Furnace, Air Cooler | Retailer |
| Model number | PM01 | Retailer |
Alternatives worth comparing
More condensate pumps we cover
Final verdict
Handy for a dehumidifier tank, not for HVAC.
Where to buy
Our links open this exact model's product page. Prices and stock change; check what's included before you order.
Each button opens this exact model. We may earn a commission on tracked links; it never changes what we publish. Disclosure


