Quick verdict
The stainless housing is what sets it apart: it can circulate drinking water in a hot-water return loop, where cast iron pumps are ruled out, and it handles heating loops too. Three speeds let you match the loop. It circulates water around a system; it does not raise house water pressure.
Who it fits, and who should skip it
A good fit if
- You have a dedicated hot-water return line to circulate.
- The water in the loop is potable.
- You want three speeds and a check valve in one pump.
Look elsewhere if
- You have no return line; an under-sink valve kit suits that.
- You want a timer built in; this model has none.
Specifications
Motor
| Horsepower | 0.12 / 0.1 / 0.08 HP (speeds 3 / 2 / 1) |
|---|---|
| Voltage | 115 V, 60 Hz, single phase |
| Power and current | 87 W 0.75 A / 77 W 0.69 A / 58 W 0.53 A |
Figures: Grundfos UP Series data booklet, UPS 15-55 SFC page and cross-reference charts.
Performance
| Max flow | 25 gpm (5.7 m³/h) |
|---|---|
| Max head | 18 ft (5.5 m) |
Figures: Grundfos UP Series data booklet, UPS 15-55 SFC page and cross-reference charts.
Control
| Check valve | Removable, built in |
|---|
Figures: Grundfos UP Series data booklet, UPS 15-55 SFC page and cross-reference charts.
Limits
| Liquid temperature | 36 to 230 °F (2 to 110 °C) |
|---|---|
| Max system pressure | 145 psi (10 bar) |
Figures: Grundfos UP Series data booklet, UPS 15-55 SFC page and cross-reference charts.
Build
| Pump housing | Stainless steel (S in the type code) |
|---|---|
| Connection | GF 15/26 two-bolt flange |
| Flange-to-flange | 6.50 in (165 mm) |
| Shipping weight | 13.2 lb (6.0 kg) |
Figures: Grundfos UP Series data booklet, UPS 15-55 SFC page and cross-reference charts; Amazon listing B003EMH9BE.
Installation and setup
Fit the pump with the motor shaft horizontal, in a vertical or horizontal pipe, terminal box to the side and cable entry down. It uses the common two-bolt GF 15/26 flange, so it fits flanges already in place from many older circulators. On a hot-water return loop it usually sits on the return line near the water heater, pumping toward the heater, with isolation valves on both sides. Purge air before switching on, as the ceramic bearings are lubricated by the water.
Grundfos's cross-reference charts list it as the replacement for several Taco 007 and 008 bronze and stainless flanged models. Copper return lines benefit from the lowest speed that keeps the loop warm.
Switch and sizing notes
The pump runs whenever it is powered; a separate timer, aquastat or boiler control decides when. Grundfos notes that if a timer is fitted on related models, liquid temperature is limited to 150 °F. The speed selector sets one of three speeds, from 58 W to 87 W.
For a hot-water return loop, flow needs are small: speed 1 is usually enough to keep the loop warm, and a higher speed mainly adds noise and erosion in copper. For a heating zone, size as you would any circulator, reading your operating point on the curve in the data booklet, which is a graphic. The built-in check valve prevents backflow and thermosiphoning. See the recirculation guide for return-line layouts.
Ownership and maintenance
No seal and no oiling: the wet-rotor design runs quietly for years if the water is clean and air-free. In hard-water areas, scale can bind the rotor in a potable loop, so keep the heater temperature moderate. The check valve can be removed if a system design calls for it. If a return loop goes cold at the far end, check that the check valve is seated and that air has been bled from the highest point before raising the speed.
Pros and cons
Pros
- Stainless housing suits potable water.
- Three speeds from 58 to 87 W.
- Built-in removable check valve.
- Common flange size for replacements.
Cons
- No timer or aquastat built in.
- Heavier than cast iron equivalents.
Alternatives worth comparing



Final verdict
Choose the UPS15-55SFC for a hot-water return loop or any system where the water is potable, with three speeds and a check valve. For closed heating only, a cast iron model does the job.
Where to buy
Each button opens this exact model's listing. We may earn a commission on tracked links; it never changes what we publish. Disclosure
Questions buyers ask
Can the UPS15-55SFC circulate drinking water?
Yes. Its stainless steel housing suits open, potable systems such as hot-water return loops, which is the use Grundfos assigns to its bronze and stainless pumps. Cast iron models are for closed systems only.
What horsepower is the UPS15-55SFC?
The data booklet lists 0.12 HP on speed 3, 0.1 HP on speed 2 and 0.08 HP on speed 1. A retail listing rounds the low speed to 1/12 HP and wrongly calls the pump single speed, so rely on the maker's table.
What Taco pumps does it replace?
Grundfos's cross-reference charts list the UPS15-55SFC for Taco 007 and 008 bronze and stainless flanged models, such as the 007-BF5 and 008-SF6, with the same flange type. Check the flange spacing before ordering.
Does the UPS15-55SFC have a timer?
No. Timer versions exist in the same family with a line cord, but the SFC is a flanged pump without one. Add a separate timer or aquastat if you want to limit run hours.
