Cast iron submersible ยท Little Giant

Little Giant 6-CIA Sump Pump (506125)

The Little Giant 6-CIA (item 506125) is a 1/3 HP cast iron sump pump switched by an internal diaphragm instead of a float. Little Giant rates it at 46 GPM at 5 ft of lift and 18 ft of shut-off head.

Model 6-CIA · part number 506125 · Updated November 2026

Horsepower
1/3 HP
Voltage
115 V, 50/60 Hz
Max flow
46 GPM (174 LPM) at 5 ft
Max head
18 ft (5.48 m) shut-off, 7.8 PSI
Switch type
Integral diaphragm (pressure) switch, non-adjustable
Discharge
1-1/2 in FNPT

Each button opens this exact model's listing. We may earn a commission on tracked links; it never changes what we publish. Disclosure

Quick verdict

In short

This pump earns its place in narrow pits. With no float arm or tether, nothing can snag on the basin wall, and Little Giant allows diaphragm models in a basin just 10 in across. It suits short lifts: flow falls to 29 GPM at 10 ft and 12.5 GPM at 15 ft, so a tall discharge run needs something stronger.

Who it fits, and who should skip it

A good fit if

  • Your basin is narrow and a tethered float keeps catching on the wall.
  • The outlet is a long way from the pit and the 25 ft cord avoids an extension.
  • Your lift is under about 10 ft, where the curve still shows 29 GPM.

Look elsewhere if

  • Your discharge climbs 15 ft or more; the curve ends at 18 ft.
  • You need adjustable on and off levels for a longer pump cycle.

Specifications

Motor

Horsepower1/3 HP
Voltage115 V, 50/60 Hz
Amps and watts9.0 A running, 14.3 A starting, 720 W
Motor typeShaded pole, oil-filled, thermal overload protection, continuous duty

Figures: Little Giant 6 Series spec sheet 995201.

Performance

Max flow46 GPM (174 LPM) at 5 ft
Flow at 10 ft29 GPM (110 LPM)
Flow at 15 ft12.5 GPM (47 LPM)
Max head18 ft (5.48 m) shut-off, 7.8 PSI

Figures: Little Giant 6 Series spec sheet 995201.

Switch

Switch typeIntegral diaphragm (pressure) switch, non-adjustable
On / off levelsOn at 7 to 10 in, off at 1 to 4 in

Figures: Little Giant 6 Series spec sheet 995201; Little Giant Model 6 Series owner's manual 993865.

Build

Discharge1-1/2 in FNPT
ConstructionEpoxy-coated cast iron motor housing, polypropylene volute, nylon non-clog impeller
Shaft sealNitrile with carbon and ceramic faces
Power cord25 ft, 18-3 SJTW, breather tube inside
Weight19.5 lb (8.85 kg)
Minimum basin10 in diameter for diaphragm models
Warranty3-year limited

Figures: Little Giant 6 Series spec sheet 995201; Little Giant Model 6 Series owner's manual 993865.

Versions

The 6-CIA name covers several item numbers that differ in cord length, voltage, switch heights and legs. Check the item number before you order.

VersionPart numberWhat differsListing
6-CIA, 115 V, 25 ft cord506125Diaphragm switch, on 7 to 10 in, off 1 to 4 in, 19.5 lbView on Amazon
6-CIA, 115 V, 10 ft cord506158Same switch levels, 18 lbNot linked
6-CIA, 230 V, 12 ft cord506166Same switch levels for 230 V circuitsNot linked
6-CIA with leg kit, 25 ft cord506164Raised switch: on 10 to 13 in, off 4 to 7 in, 20 lbNot linked
6-CIA-RFS, piggyback float506171Remote mechanical float, on 9.5 to 11.5 in, 10 ft cordNot linked
6-CIA-RS, piggyback diaphragm506267Remote diaphragm switch, off 3 to 5 in, 10 ft cordNot linked

Figures: Little Giant 6 Series spec sheet 995201.

Installation and setup

Little Giant's general advice is a basin at least 18 in wide and 24 in deep, but it notes that diaphragm switch models can work in one only 10 in across. Center the pump on a hard, level surface; clay, earth and gravel let small stones reach the intake. Keep the discharge short with few elbows and never smaller than the 1-1/2 in outlet, and fit a union just above the basin cover so the pump can come out without cutting pipe.

Install the full-flow check valve horizontally, because solids can settle in a vertical valve and hold it shut at start-up. Between the pump and that valve, below floor level, drill a relief hole of 1/8 in or 3/16 in; without it the pump can air lock and run without moving water. Tape the cord to the pipe, and plug it into a GFCI outlet set at least 4 ft above the floor. Little Giant says not to use an extension cord.

Switch and sizing notes

Instead of a float, the 6-CIA senses depth through a rubber diaphragm. Rising water presses on it and closes the switch; as the level drops, the pressure eases and the pump stops. For that to work, the switch breathes through a tube that runs inside the power cord to the plug. A kinked, pinched or blocked cord can stop the pump from starting or from shutting off, so route it in gentle curves.

The switch starts the pump at 7 to 10 in of water and stops it at 1 to 4 in, with no adjustment. Size from the curve: 46 GPM at 5 ft, 29 GPM at 10 ft and 12.5 GPM at 15 ft. The sizing calculator adds pipe friction to your vertical lift, and the guide to switch types compares a pressure switch with vertical and tethered floats.

Ownership and maintenance

Little Giant asks for an inspection every three months, more often in heavy use: check the cord and outlet, clear debris and sludge from the basin, then run a test fill. While the pump runs, a thin stream should spray from the air bleed hole and from a hole in the pump base; both are normal. The motor is sealed and oil-filled, so never add oil, and let it cool for two hours before handling.

The cord cannot be replaced, so a damaged one means a new pump. A worn diaphragm can be swapped with switch kit SPRK-1 (599300). Little Giant's limited warranty runs 3 years from purchase.

Pros and cons

Pros

  • No float to snag in a narrow pit.
  • Long 25 ft cord on this item number.
  • Diaphragm switch kit sold separately.
  • Cast iron motor housing with oil cooling.

Cons

  • Flow drops sharply above 10 ft.
  • Switch levels cannot be adjusted.
  • Breather tube makes cord routing matter.

Alternatives worth comparing

Final verdict

Pick the 6-CIA for a tight basin and a short lift, where a float-free switch and a long cord solve real problems. If water must climb much past 10 ft, a pump with more head will empty the pit faster and run less.

Where to buy

Each button opens this exact model's listing. We may earn a commission on tracked links; it never changes what we publish. Disclosure

Questions buyers ask

How does the Little Giant 6-CIA turn on without a float?

A diaphragm inside the switch housing feels water pressure. When water rises to about 7 to 10 in, the pressure closes the switch; when it falls to about 1 to 4 in, the switch opens. A breather tube in the cord lets the switch reference outside air, so keep it unpinched.

What is the difference between the 506125 and 506158?

Both are 115 V 6-CIA pumps with the same switch heights and curve. The 506125 has a 25 ft cord and weighs 19.5 lb; the 506158 has a 10 ft cord and weighs 18 lb. Pick by the distance from the pit to a GFCI outlet, since an extension cord is not allowed.

Can I use the 6-CIA to drain a flooded basement?

The retail listing warns against general dewatering or emergency water removal with this automatic pump, because the switch needs a pit to work as intended. For a flooded floor, a manual utility pump is the better tool, and the 6-CIA can then return to sump duty.

Why does water spray from the base of the pump?

Little Giant builds a bleed hole into the base so trapped air can escape and the impeller can prime. The manual calls the spray completely normal. Make sure it lands inside the basin, and clean the hole if the stream stops.